It will work with Toshiba Satellite and is compatible with legacy SATA interface 2, 1.5 and 1 Gb/s.The sequential read/write speeds were 2 to 3 times that of a hard disk. The read/write 4KiB benchmarks have improved 30 times. Using an i3 processor PC, the difference in benchmarks using HDD and SSD can be seen. You can get the maximum performance using this interface cable, as it is optimized for this kind of specification. The speed benchmarks almost doubled using 6 gbps version. The Kingston 240GB A400 SSD 2.5” SATA 7MM 2.5-Inch SA400S37/240G was benchmarked with CrystalDiskMark 6.0.2 圆4 in April 2019 using SATA 6 gbps, and another with SATA 3 gbps. The boot times have reduced to below 30s after using 120GB Kingston A400 SSD in 2017.īecause most of our computers are at least three years old, the hardware only supports SATA II, so we’re not seeing the huge improvement in speed that we might if we were going from HDDs to upper-limit SATA III speeds, but regardless, speeds have more than doubled in the four computers I’ve swapped these into so far, and users are seeing improvements, particularly in startup speeds for the computer (from more than 3 minutes down to 30 seconds) and for individual programs.The read/write speeds almost doubled, even with a SATA 2 interface slot. The difference between HDD and SSD can be seen in the image below. The maximum speed of the SSD will be reduced when using SATA 1 AND II ports, due to lower speed limitations of the port. It has a 7mm form factor to wider array of systems.Īs you can see the expected read/write speeds are less than using a SATA 3 interface. The below image are benchmarks taken with CrystalDiskMark 5.2.1 on a 64 bit OS, using SATA 2 slot. Though it performs the best using a SATA III (6Gb/s) cable, it is reverse compatible with SATA II (2Gb/s) and SATA 1.5 (1.5Gb/s) motherboard slots. Battlefield 1 maps load quickly in less tha 10 secs using this SSD drive. ![]() ![]() The 120GB Kingston A400 performs 10x times better than a common hard-drive.
0 Comments
Leave a Reply. |